Filter
Top Products
30
© 2001 directed electronics, inc.
qquuiicckk rreeffeerreennccee gguuiiddee
To arm using your remote
➤ You can activate, or arm, the system by pressing on your transmitter for
one second. When the system arms, you will hear a short siren sound, or chirp,
and see the parking lights flash once. If the vehicle’s power door locks have been
connected to the system, the doors will lock.
To disarm using your remote
➤ To disarm the system, press . You will hear two chirps, and the parking
lights will flash twice. If power locks are connected to the system, the doors will
unlock. If the siren chirps either four or five times when disarming, see
Diagnostics section. This is called Tamper Alert.
Arming while driving
➤ Press on your transmitter while the vehicle is running. The system will
chirp once and then once more to indicate that the ignition is on.
Disarming without a transmitter
➤ Turn on the ignition. Press the Valet switch the programmed number of times
within 15 seconds. The system should now disarm. If it does not, you may have
waited too long. Turn the ignition off and on and try again.
To enter or exit Valet Mode
➤ Turn ignition to "run" position, then turn to "off" position. Press and release
the Valet switch within 10 seconds. The status LED will light solid if you are
entering Valet Mode, and it will go out if you are exiting Valet Mode.
To activate Panic Mode
➤ Press and hold down for 1.5 seconds.
To exit Panic Mode
➤ Press on the transmitter.
To activate Remote Controlled Chirp Muting
➤ Press briefly before arming or disarming, and the confirmation chirp(s)
will be eliminated for that one operation only.
Location of Valet Switch______________________________________
Number of Valet switch pulses for disarming____________________
Cut along dotted line and fold for a quick and easy reference to keep in your purse or wallet.
✂✂
✂✂