Filter
Top Products
12
© 2001 directed electronics, inc.
The status LED will light steadily if you are entering Valet Mode
and will turn off if you are exiting Valet Mode.
remote valet
The operations described in this section refer to transmitter
buttons. Remember, the buttons used in all the instructions in
this guide correspond to a Standard Configuration transmitter.
This may not be how your transmitter is set up.
1. Open any vehicle door.
2. Press .
3. Press .
4. Press again.
The status LED will light solid if you are entering Valet Mode,
or will go out if you are exiting Valet Mode.
false alarm control technology (FACT)
Your system offers FACT, a feature that prevents annoying
repetitive trigger sequences due to faulty door pin switches or
environmental conditions such as thunder, jackhammers, airport
noise, etc.
Here’s how it works: The alarm triggers three times. Each time,
the same sensor or switch is triggering the alarm. The three trig-
gers are within 60 minutes of each other. FACT will interpret
this pattern of triggers as false alarms. After the third trigger,
➜
➜