Filter
Top Products
27
© 2008 Directed Electronics. All rights reserved.
To enter turbo timer mode with a manual transmission:
Perform the manual transmission procedure with the door open. Transmit the
timer mode feature with the remote by pressing two-times, and then press
A U
X
.
After exiting the vehicle, lock the system and the vehicle remains running for the
programmed runtime. (The remote start feature is still enabled).
You can still remote start the vehicle after the turbo timer has timed out and shut
Off the vehicle. For safety reasons, if a door is opened (while the system is
Locked or Unlocked) while you are away, the remote start exits the manual trans-
mission mode and will not remote start until the MTS sequence is re-initiated.
Note: An optional push button can be hardwired to the (-) activation input on the
remote if you want to activate the turbo timer without using the remote start.
When the vehicle is running follow the procedures listed above, but instead of
pressing the remote, press the push button the appropriate number of times to
activate the remote start (factory setting is for 1 pulse).
The remote emits the remote start confirmation tone, after which you can turn
Off the ignition and exit the vehicle. The car remains running for the pre-pro-
grammed amount of time.
➤ Smart start activation
With Smart Start you can activate remote start when the vehicle reaches a cer-
tain temperature, or when it reaches a certain voltage.
The factory setting for temperature high is 100º, and the low is 0º (F). The
voltage setting is 10.5v. These settings can be adjusted or turned off by your
installer using the Bitwriter.