Filter
Top Products
26
© 2008 Directed Electronics. All rights reserved.
To exit timer mode without the transmitter:
Make sure the remote start system is not operating the engine.1.
Turn the ignition on. Timer Mode is exited and the parking lights flash 2.
slowly four times.
Note:
The Bitwriter can change the amount of times the remote start activates
and, it can change the intervals between activations in timer mode.
➤ Turbo timer mode
To activate turbo timer mode:
Make sure turbo timer is turned on.1.
Open the vehicle door.2.
While the vehicle is running, press 3. button 2-times, and then press
A U
X
button. The parking lights flash one-time and the remote sounds the activa-
tion tone confirming that the remote start is activated.
Note: The 1-way remote only flashes the parking lights and does not emit
any sounds.
Turn Off the ignition. The car remains running. 4.
Exit the vehicle and Lock the system. The vehicle remains running for the 5.
programmed run time.