Filter
Top Products
32
© 2008 Directed Electronics. All rights reserved.
remote will respond with error tone.
Rear defogger
Command
: Press
AUX
four times, and then
AUX
. (Only after remote
start is on.)
Feedback
: Defogger icon appears on remote and text reads Defrost
On.
Notes
: While the remote start is running the defroster will manu-
ally be turned on for one remote start cycle. When the
remote start shuts down, the defroster will work normally.
The defroster turns on when the temperature inside the
vehicle is 55 degrees or below when this feature is
wired and enabled.
Smart start
Command
: Press
AUX
three-times and then press
AUX
.
Feedback
: The vehicles parking light ash 5 times fast and the text
on the 2way remote reads Smart Start On
Notes
: Enables or disables the SmartStart feature. The smart
start feature of this system will allow you to have the
remote start activate when the vehicle reaches a certain
temperature (hot or cold) or a certain voltage. The fac-
tory setting for temperature high is 100 °F the setting for
low is 0 °F. The voltage setting is for 10.5V.
These settings can be adjusted or turned off by your
installer when using the Bitwriter.
To activate the Smart Start Mode with a manual transmission:
Enter the MTS procedure.1.
Exit the vehicle and press the 2.
AUX
button on the remote (the vehicle