Directed Electronics 50.7X Remote Starter User Manual


 
29
© 2008 Directed Electronics. All rights reserved.
running. If the vehicle shuts down when locking, then the unit did not
enter valet take-over mode.
Timer mode
Command
: Press
AUX
two-times and then
AUX
.
Feedback
: Small timer icon appears and text reads “timer start on”.
The vehicle will confirm with 4 fast parking light flash-
es.
Notes
: Enables or disables the remote start timer mode.
The system must be armed for the timer mode to operate. The system
will start every 3 hours for a maximum of six cycles until canceled by the
brake, hood, or neutral safety shut-down wires. The remote will respond
with the Start and Stop remote start notification during each Start and
Stop of the Vehicle while in Timer mode.
Important:
Use Timer Mode in open areas only. Never start
and run the vehicle in an enclosed space such as a garage
or carport.
To activate timer mode with a manual transmission:
Enter the MTS mode.1.
Exit the vehicle and arm the alarm. 2.
Enter the timer mode. The parking lights quickly flash 4 times to confirm 3.
entry into timer mode (vehicle does not remote start at this point). Vehicle
begins the timer mode sequence.
To exit timer mode with transmitter:
Press
AUX
twice and then press
AUX
. Parking lights flash slowly four times
conrming timer mode is exited.
To exit timer mode without transmitter:
Make sure the remote start system is not operating the engine.1.