Filter
Top Products
26
© 2011 Directed Electronics. All rights reserved.
Owner recognition
Owner recognition lets up to four users of the system have unique settings to
meet their specific needs. It is almost like having four separate systems in your
vehicle, one for each user. This feature is only available to authorized dealers
using the Bitwriter programming tool.
Rapid resume logic
This Directed system will store its current state to non-volatile memory. If power
is lost and then reconnected the system will recall the stored state from memory.
For example, if the unit is in Valet Mode and the battery is disconnected for
any reason, such as servicing the car, when the battery is reconnected the unit
is still in Valet Mode. This applies to all states of the system including lock or
unlock.
Power saver mode
Your system will automatically enter Power Saver Mode while locked or in
Valet Mode, after a period of time in which no operation has been performed.
This lowers the current draw on the vehicle’s battery. Power Saver Mode takes
over under the following conditions:
Power Saver when the system is locked: After the system has been Locked for
24 hours the status LED on the Control Center flashes at half its normal rate,
decreasing the system’s current draw.
Power Saver in Valet Mode: When the system enters Valet Mode the Status
LED on the Control Center illuminates steadily. If the vehicle is not used (ignition
is not turned on) for a one-hour period while the system is in Valet Mode, the
status LED shuts Off. If the system remains in Valet Mode, the LED comes back
on the next time the ignition is turned On, and then Off.