Filter
Top Products
18
© 2011 Directed Electronics. All rights reserved.
➢ Manual transmission vehicles
When installed into a manual transmission vehicle, the system requires that the
MTS mode is properly set when parking. If MTS mode is not properly set or is
defeated after being properly set the system will not start the engine.
To set manual transmission mode when parked:
1. With the engine running and transmission in neutral,
set
the parking
brake and leave the engine running.
Note: For Pit Stop or Turbo Timer mode (to leave the engine running after
locking)
open
the driver door.
2.
Release
the foot brake (if pressed during Step 1), or
press
and
release
the foot brake anytime. As long as the engine is running there is no time
limit to perform this step.
3. Within 20 seconds of foot brake release,
press
any command button
on the remote, after 20 seconds return to Step 2 (For Turbo Timer Mode,
press the optional dash mounted activation button, or send the Timer
Mode command from the Advanced Start menu).
Note: If foot brake is pressed anytime, MTS mode will not activate.
4. The vehicle lights flash 5 times to confirm MTS mode is enabled and the
remote start activates the ignition outputs.
5.
Turn
Off and
remove
the key from the ignition switch, the engine remains
running.
6.
Exit
the vehicle,
close
all the doors and
lock
the system.
7. The engine turns off after a few seconds. If the door is opened in Step 3
then the engine continues to run.
You can now remote start the vehicle. If a door is opened before the next
remote start activation, the system will not remote start the vehicle.
To drive your automatic or manual transmission vehicle after it has been remote
started:
1. Get in without stepping on the brake.