Filter
Top Products
20
© 2011 Directed Electronics. All rights reserved.
To exit timer mode without the transmitter:
1. Make sure the remote start system is not operating the engine.
2. Turn the ignition on. Timer Mode is exited and the parking lights flash
slowly four times.
Note:
Your authorized Directed dealer using the Bitwriter® programming tool
can change the amount of times the remote start activates, and change the
intervals between activations in timer mode.
➢ Turbo timer mode*
Turbo timer mode keeps the engine running after arriving at your destination
for a programmable period of 1, 3, 5 or 10 minutes. This allows the system’s
timer to conveniently cool down the turbo after you have left the vehicle. Turbo
timer mode can be activated by the remote or optional dash mounted activa-
tion button.
To activate turbo timer mode with automatic transmission:
1. While the vehicle is running, press
A U
X
button 2-times, and then press
A U X
button. Or you can press the optional dash mounted activation button
one time. The vehicle lights turn on and the remote start activates the igni-
tion outputs. The parking lights flash one-time confirming that the remote
start is activated.
2. Turn Off the ignition. The car remains running.
3. Exit the vehicle and Lock the system. The vehicle remains running for the
programmed run time.
*Must be turned on by an authorized Directed dealer.
To activate turbo timer mode with a manual transmission:
Perform the manual transmission procedure (See Manual transmission vehicles)
with the door open. At step 3, transmit the timer mode feature by pressing
A U
X
two-times, and then press
A U X
.
Or press the optional dash mounted activation button one time. The lights turn
on and the remote start activates the ignition.
After exiting the vehicle, close all the doors and lock the system. The vehicle