Filter
Top Products
Mounting monitor, ill. 8
A
Never install the monitor in an area where the head could impact in case of an
accident!
The monitor can be fastened with the supplied support either in normal or in
suspended position. If it is mounted in suspended position, make sure that the display
contents is rotated 180 degrees (“System settings” menu, option “Display”).
Glueing the support
1. Fix the mounting plate with two Phillips head screws to the bottom of the monitor
support.
2. Install monitor connector with the two countersunk screws to the monitor support,
see ill. 9.
3. Slide monitor on the connector until it clicks into position.
4. Determine the mounting position of the monitor.
5. Remove the monitor from the support.
CAUTION: When removing the monitor from the support, always make sure to press
the release key on the rear of the connector!
6. Clean the surface from grease and dust with methyl alcohol.
7. Remove protective paper from one side of the supplied adhesive tape and stick it to
the bottom of the mounting plate.
8. Remove protective paper from the lower side of the adhesive tape and place the
monitor support onto mounting surface and press firmly.
Note: Mounting temperature should be at least 60 degrees Fahrenheit to ensure the
full adhesive effect of the tape.
Screwing the monitor support
Screw monitor support without mounting plate directly in place with two appropriate
screws.
Alternative mounting
To extend the mounting possibilities you can also mount the monitor without the
supplied support:
Directly stick the monitor on the dashboard with double-sided self-adhesive tape.
See your dealer for other alternative mounting possibilities.
A
Observe safety warnings concerning driver’s sight and airbag inflation area!
Installing holder for the remote control, ill. 10 - 11
Mounting on angle bracket
Screw holder to angle bracket. Either insert angle bracket into an available slot or
screw it in place.
Mounting with adhesive plate
Snap holder onto plastic plate. Remove protective paper from adhesive tape. Stick
holder with adhesive plate onto mounting surface and press firmly.
Note: Mounting temperature should be at least 60 degrees Fahrenheit to ensure the
full adhesive effect of the tape.
MOUNTING INSTRUCTIONS
47
English