Filter
Top Products
21
You have the following option from the Alarm On/Off Screen:
❏
Toggle the Alarm Setting
To toggle the alarm setting from On to Off (or vice versa),
press and release SET/CLEAR. Each time you press SET/
CLEAR, the display changes to read ON or OFF, depending
on the alarm’s status.
Calibration Screen
The Calibration screen enables you to calibrate the DriveRight 600 for
your vehicle. See “Calibrating the DriveRight 600” on page 6 for
details.
Limit and Unit Settings Screen
The Limit and Unit Settings screen allows you to set limits for speed,
acceleration, and deceleration. You may also change the unit of mea-
sure in which speed and distance information is displayed (km/h or
MPH).
Limit Entry Screen
You have the following options from the Limit and Unit Settings Screen:
❏
Enter/Change a Limit
Use SET/CLEAR to change the active digit and use PLUS
and MINUS to enter the desired limit for speed, acceleration,
and deceleration.
NOTE: The maximum limit settings are as follows: Speed 255,
Acceleration and Deceleration 2.55.
❏ Change the Unit of Measure
Press and release SET/CLEAR until the display segment
(km/h or MPH) is flashing. Use PLUS and MINUS to toggle
between km/h and MPH. Whatever segment is displayed
when you press MODE to exit this screen is the unit of mea-
sure in which speed and distance information will be dis-
played.
k
m
/
h
A
CC
E
L
G
G
D
E
C
E
L
S
E
TT
I
N
G
S
SP
EE
D
Speed Limit
Deceleration Limit Acceleration Limit
DR600 UG Rev B D008.fm Page 21 Thursday, April 17, 2003 7:17 AM