Filter
Top Products
WIRING
PIN 6: GREEN: (-) START ACTIVATION INPUT & TURBO TIMER INPUT
See descriptions below & diagrams at right:
Momentary
Switch
Turbo Timer Mode
GREEN
GREEN
(Not included)
(Aux Channel
AFTERMARKET
1 sec. (-) pulse
Output)
ALARM / KEYLESS
TEMP SENSOR
or
Auxiliary Start Input
(-) NEGATIVE START TRIGGER INPUT: a 1-
Second Negative Ground pulse on this wire will
trigger a remote start or stop a remote started
engine. Connect the Green wire to optional
outside sensors such as the Crimestopper RS-400
CoolStart Temperature/Timer module. This wire
can also be connected to the Negative output
channel of an alarm or Keyless entry system.
TURBO TIMER INPUT: This wire allows the
system to keep a vehicle running for 1-5 minutes
[selectively] after removing the key. This mode
requires the use of a momentary switch that is not
included with the kit. Connect a 2-pole momentary
switch with one side to chassis Ground and the
other side to the Green input wire. If you own a
turbo or turbo diesel vehicle, you can now allow
the EZEE Start system to keep your engine
running for 1-5 minutes after exiting/locking your
vehicle to cool-down without the need for an
external “Turbo Timer”.
NOTE: The turbo timer button will also trigger a remote start if it is inadvertently pressed when the vehicle is
not running. Please note this when installing the button and choose a location out of harm’s way
PIN 5: GRAY: (-) NEGATIVE HOOD PIN SWITCH (REQUIRED FOR PROGRAMMING)
Connect the Gray wire to a switch that is at ground when the hood is open. If an existing switch is not available, then we
recommend installing the supplied pin switch. When this wire is grounded, (hood is open) the remote start is inhibited.
The hood pin is required for option and remote transmitter programming. If installing the supplied pin switch, find a
location around the perimeter of the engine compartment. Do not to mount pin switches in water pathways. A small
Brown wire is included in the kit when connecting the pin switch.
5