Filter
Top Products
DIESEL GLOW PLUG DELAY
This feature provides a solution for diesel vehicles that require a delay for glow plug warm up. You can choose from a
selection of “pre-cranking” delay times.
NOTE: This feature is OFF by default and must be programmed before use. Once a delay time is selected, the Remote
start unit will always wait the programmed time before cranking EVEN IF the glow plug warms up first. There are 3
different Delay times available for use: 10, 20, or 30 seconds. See Program Option chart next page.
HOW TO USE THIS FEATURE:
1. See the “Option Programming” section below and change option #6 from "Normal" to one of the delay time
values.
2. Once this option has changed, the system will wait for the selected time before cranking.
OPTIONS PROGRAMMING
This CoolStart system has 7 programmable control options to customize the system for various operating features and
installer preferences. Examine the chart on the next page along with reading the descriptions that follow. You may
change one option at a time, or program multiple options in one session. If you start with the lowest option and continue
on to higher options, you do not need to repeat steps #1-3 each time. For example, you can change Option #2 to “ON”,
then you can continue pressing the program button to get to a higher number option and change it as well. You can only
go from lower to higher options in one session.
To Engage Option Programming:
1. Open hood (If no hood pin switch is installed, then ground the Gray wire)
2. Turn Key to the ON position. (Do not start vehicle)
3. Press the program/valet button 5 times. After a few seconds the unit will flash the lights 5 times.
4. Press the program/valet button [again] the number of times that corresponds to the option number desired (1-
7X). You must get a light flash after each button press. If the system did not flash the lights, then it did not
register your press. Press carefully and do not lose count.
5. Press the Lock/Unlock button on the remote select an option value. The lights flash 1X for Button 1; Twice for
Button 2 and so forth. See chart NEXT PAGE for values.
6. When finished changing options, turn Ignition OFF, close hood (or un-ground Gray wire) and check for changed
features.
13