Filter
Top Products
RS-840 TRANSMITTER CODE LEARNING
Transmitter Code Learning:
Notes: Remote Transmitters come pre-programmed from the Factory. When re-learning remotes or adding remotes,
ALL your system’s remote codes must be learned at time of programming!! These systems allow storage of up to 4
different remote codes in memory. Antenna / Receiver must be plugged into unit.
1. Open hood (ground the Gray hood pin wire if no hood pin is installed.)
2. Turn key to the ON position. (Do not start vehicle)
3. Press Program/Valet button 4 times. After a few seconds, the unit will flash the parking lights 4 times.
4. Press Button #1 (Lock) of the transmitter to be learned. You should get 2 light flashes indicating the code-learn. Now
the unit is waiting for a 2
nd
code, so repeat this step as needed with up to 3 additional remotes. The unit will flash the
lights in succession after each code learned for up to 4 codes. (2 flashes for the 2
nd
code, 3 flashes for the 3
rd
code
etc.) If all 4 codes are learned, the unit will automatically exit code learning mode, otherwise turn key OFF and close
the hood. (See Diagram Below)
IGN
OFF
WAIT FOR
4 FLASHES
PRESS 4X's
FLASH 2, 3, or 4 X's
(GRAY WIRE GROUNDED)
IGN
OFF
PRESS
LOCK BUTTON
COMPLETE
16