Filter
Top Products
WIRING
ORANGE WIRE: NEGATIVE ARMED OUTPUT
This wire provides a constant GROUND output when system is locked with the remote transmitter. This
output can used for a starter disable relay, or a device such as a window roll-up module. See System Wiring
Diagram. On page
GRAY WIRE: (-) AUXILIARY REMOTE OUTPUT 1 (Optional, requires relay)
Negative output controlled by pressing Button #3 (Trunk Symbol) for at least 1 second.
BROWN/WHITE: (-) HORN HONK/CHIRP OUTPUT (Optional, requires relay)
This wire provides a negative pulse output to honk/chirp the factory horn for audible lock/unlock confirmation.
Connect Brown/White to terminal 85 of a relay. Connect terminal 86 to +12V Constant. Connect terminal 87
to +12V or GROUND depending on the type of horn activation circuit in the vehicle. Connect terminal 30 to
the horn activation circuit. NOTE: Many vehicles use a Negative type of horn circuit, however we recommend
that you test the circuit on your vehicle before making any connections to avoid any possible damage.
GREEN WIRE: NOT USED (No Connection)
YELLOW WIRE: IGNITION SWITCHED “ON” AND “START” +12 VOLTS
Connect to an ignition wire that shows +12 Volts when the key in both “On” and “Start” positions.
BLACK WIRE: SYSTEM CHASSIS GROUND
THIS WIRE MUST BE CONNECTED TO CHASSIS METAL OF THE VEHICLE. Scrape away any paint or dirt
from the connection point to ensure a good connection. Keep ground wire short.
RED WIRE: +12V POWER INPUT (15 amp fuse)
Connect to +12 Volt source with supplied fuse & holder. Recommended location for this connection is at the
vehicle battery positive terminal.
POWER DOOR LOCK WIRING
6 PIN DOOR LOCK OUTPUT PLUG (On-Board Relays):
VIOLET (Fused 10A): UNLOCK Normally Open (Terminal 87 On-board Unlock Relay)
BROWN/BLACK: UNLOCK Normally Closed (Terminal 87A On-board Unlock Relay)
BLUE/BLACK: UNLOCK Output (Terminal 30 On-board Unlock Relay)
VIOLET/BLACK (Fused 10A): LOCK Normally Open (Terminal 87 On-board Lock Relay)
WHITE/BLACK: LOCK Normally Closed (Terminal 87A On-board Lock Relay)
GREEN/BLACK: LOCK Output (Terminal 30 On-board Lock Relay)