Filter
Top Products
TABLE OF CONTENTS
Pre-Installation & Component Mounting……………………..……………………………………………………2-3
Wiring……..……………………………………………………………………………………………………….…….3-4
Power Door Lock Wiring……………………………………………………….………..………………….…..……4-6
Jumper Diagram………………………………………………………………………………………………………….7
System Wiring Diagram.………………………………………………..………………………………………...…….8
Transmitter Programming………………………………………………………………………………………………9
Option Programming…………………………………………….……………………………….………….…...…9-10
Option Reset……………………….…………………………….……………………………….……………..………10
Operating Instructions………………………..……………………………………………………………..…….11-12
PRE-INSTALLATION CONSIDERATIONS
To ease installation, we suggest that you READ THIS MANUAL before beginning your installation.
BEFORE BEGINNING, check all vehicle manufacturer cautions and warnings regarding electrical service (AIR
BAGS, ABS BRAKES, ENGINE / BODY COMPUTER AND BATTERY).
PLAN OUT YOUR INSTALLATION and determine most suitable locations for all components to be placed.
These components include: the module itself, valet/program button and possible relays. Allow enough wire to
create a service loop with strain relief, should servicing be required.
DAMAGE resulting from incorrect installation or failure to follow guidelines stated in this book will not be
covered under warranty and subject to repair or replacement charges.
USE A VOLT/OHM METER to test and locate all connections. Test Lights can damage a vehicle’s computer
systems.
ADDITIONAL PARTS, which are not included with this unit, may be needed for your particular vehicle. .
These items may include extra relays (Part#CS-402A) or Special “Data Bus” interface modules.
DO NOT ROUTE ANY WIRING THAT MAY BECOME ENTANGLED with brake, and gas pedals, steering
column, or any other moving parts in the vehicle.
REMOVE MAIN SYSTEM FUSE (S) before jump starting the vehicle or charging the vehicles battery.