Filter
Top Products
HANDS-FREE TRANSMITTER PROGRAMMING
This system can code learn up to 4 different transmitters. All transmitters must be learned at one time.
1. Turn ignition switch on and off 3 times leaving it on the 3
rd
time. (on/off, on/off, on) LED will Flash 3 times.
2. Push the Valet/Programming button for 5 seconds until the in-dash LED flashes 5 times.
3. Press the Button on the hands-free transmitter once – The dash LED will flash once to confirm
programming. Repeat this step within 5 seconds for up to 3 additional transmitters.
4. Turn off ignition.
FEATURE PROGRAMMING
NOTE!: YOU MUST TURN OFF ALL REMOTES BERORE PROGRAMMING ANY FEATURES! SEE
OPERATION INSTRUCTIONS FOR TURNING OFF REMOTE.
1. Turn Key to the ON position
2. Within 10 seconds press the Valet/Program button 5 times. The System LED will flash 3 times to confirm
you are in programming mode.
3. Now press the Valet/Program Button the number of times that corresponds the option in the list below. The
System LED will flash once each time you press the Valet/Program button.
4. Once you are at the desired feature, momentarily press the Button on the Remote Transmitter to change
the option. The System LED will flash ONCE to turn the feature ON, or flash TWICE to turn the feature
OFF.
Feature Feature Description
ON
(Default)
LED
OFF
LED
1. Auto Lock With Ignition ENABLED 1 DISABLED 2
2. Unlock when disarmed ENABLED 1 DISABLED 2
3. Horn Chirp for Arm/Disarm DISABLED 1 ENABLED 2
4. Single/Double Unlock
Pulse
1 Pulse 1 2 Pulses 2
5. 1 or 3 Second Lock Pulse 1 Second 1 3 Second 2
6. Wire #9 Function 30 Sec
Domelight
1 Factory Disarm 2
Restore All Options:
To restore all features to the Factory Default (“ON” column) position, follow steps 1 & 2 above, then
immediately press the button on the remote transmitter one time. The system LED should flash 4 times and
the programmable features 1-6 will operate as in the “ON” default column listed above.