Filter
Top Products
ORERATING INSTRUCTIONS
Turning the Remote OFF (Stop sending signals):
Press and hold the remote button for 5 seconds until LED on remote flashes twice (Ignore first single flash).
The remote is now OFF and will not send signals. When you are going to be away from your vehicle for
extended periods of time, it is advisable to turn the remote off to save its battery life. However before you
return to your car, you must re-activate the remote or press the button using it manually.
Remote Status: ON or OFF? (How to check it):
Press the button on the remote and observe the LED. If it flashes ONCE, then it is on, or if the remote flashes
TWICE it is OFF. You can perform this simple check at anytime to check the status of the remote.
Active Re-Arming:
Once the system is disarmed, it will automatically re-arm itself after 30 seconds unless the Ignition is turned
on.
Alarm System Trigger:
Once the system is armed, it will trigger if an attempt is made to turn the Ignition ON or “Hot-Wire” the vehicle.
The horn will honk for a 30-second duration and will automatically reset if no further attempts are made.
NOTE: This is an immobilizer only, therefore it WONT: warn away, trigger upon door opening, or utilize
a siren.
Care of the Remote:
You should care for your hands-free remote transmitter just as you would for an alarm system remote control.
Do not submerge the remote in water or subject it to severe abuse.
Valet Mode:
Your CS-8050 system can be temporarily disabled from automatically arming for vehicle servicing or valet
parking. Turn the key on, then press and hold the Valet button for 5 seconds to put the system into Valet
mode. Repeat this procedure to exit the Valet mode. Once the system is in the Valet mode, the LED will stay
on when the Ignition is turned on and it will flash when the Ignition is off. The system will still arm/disarm
manually with the remote button during valet.
Emergency Override:
If you lose your remote or it becomes damaged and your immobilizer system is armed, you must perform an
Emergency Disarm in order to operate your vehicle. Turn the key on, then press and hold the Valet button for
10 seconds to disarm.