Filter
Top Products
Page 7
1. Disarm the system by use of the transmitter, or by use of the emergency
override sequence. Turn the ignition switch to the ON position.
2. Within 10 seconds, press and release the valet/override button 3 times.
3. Within 10 seconds turn the ignition switch OFF, ON, OFF, ON, OFF, ON.
(The siren/horn will sound and the lights will flash one time.)
4. Within 10 seconds, begin to enter your chosen 10ths digit by pressing
and releasing the button from 1 up to 9 times.
5. Within 10 seconds of the last entered 10ths digit, turn the ignition switch
OFF then ON.
6. Within 10 seconds, begin to enter your chosen units digit by pressing and
releasing the button from 1 up to 9 times.
7. Finish by turning the ignition switch to the OFF position.
If the new code was accepted, the system will report back the newly entered
code, by flashing the LED, first indicating the 10ths digit, pause and then the
units digit. The system will report the new code three times with a one second
pause between each code, then the system will begin arming. If the LED flash
pattern reports the previously stored code, the new code was not entered
correctly. Please repeat steps 1 through 7 above considering the following.
NOTE: Acceptable digits 10ths or units are 1 through 9. The system will not
recognize a 0 (Zero), or no digit entered in any place, units or tenths.
NOTE: If 15 seconds of inactivity expire, or if the ignition switch is turned off for
more then 5 seconds during any of the above steps, the system will revert
back to the last successfully stored code.
CUSTOM CODE PROGRAMMING EXAMPLE:
To change the code from the factory pre-assigned code of 11 to "52" you
would do the following:
1. Disarm the system by using the transmitter or by using the emergency
override sequence.
2. Turn the ignition switch to the ON position.
3. Within 10 seconds, press and release the valet / override button
3 times.
4. Within 10 seconds, turn the ignition switch OFF, ON, OFF, ON, OFF, ON.
(The siren/horn will sound and the lights will flash 1 time).