Code Alarm CA611 Remote Starter User Manual


 
Page 2
Your Remote Start Alarm System has many features and available options
some of which are selected at time of installation. Consult your installing
dealer for options that may have been installed and are not listed.
ARMING THE SYSTEM:
1. Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk.
2. Press and release the Arm button of your transmitter one time.
The parking lights will flash once, the siren will chirp once, and the LED will
begin to flash slowly confirming the system is armed. If you have the optional
door lock/unlock circuit installed, the doors will lock.
NOTE: If the siren/horn sounds 3 chirps, then you have left a door, trunk, or
hood ajar. Simply close the opened entry point to provide full protection. If the
siren "chirped" 3 times, sometime after arming, the exclusive delayed dome
light learn circuit has been programmed and the system detected a open
entry point after the learned delay expired. Again, closing the hood, trunk, or
doors will correct the problem and you do not need to disarm the system to
make the correction. If the siren/horn did not sound when arming, then the
chirps have been turned off and you should refer to the section titled
"ELIMINATING THE NORMAL ARM/DISARM CHIRPS" (page 9) of this manual.
SILENT ARMING:
1. Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk.
2. Press and hold the Arm button of your transmitter for 2 seconds.
The parking lights will flash once, and the LED will begin to flash slowly
confirming the system is armed. The siren will not chirp. If you have the
optional door lock/unlock circuit installed, the doors will lock.
NOTE: If the siren/horn sounds 3 chirps, then you have left a door, trunk, or
hood ajar. Simply close the opened entry point to provide full protection. If the
siren "chirped" three times, sometime after arming, the exclusive delayed
dome light learn circuit has been programmed and the system detected a
open entry point after the learned delay expired. Again, closing the hood,
trunk, or doors will correct the problem and you do not need to disarm the
system to make the correction. If the siren/horn did not sound when arming,
then the chirps have been turned off and you should refer to the section titled
"ELIMINATING THE NORMAL ARM/DISARM CHIRPS" (page 9) of this manual.