Code Alarm CA-140 Automobile Alarm User Manual


 
6
Using Your Remote Transmitter (cont.)
Disabling the IT-s Interior Theft Sensor
It may be necessary at times to disable the IT-s Interior Theft Sensor,
especially when parking in areas (like parking garages) where
extreme vibration may cause false alarms. Press the LOCK button
and then press the FIND/PANIC button within two seconds of
pressing LOCK to disable the interior theft sensor. The siren will
chirp two times to indicate that the sensor is disabled. The sensor
will become enabled again the next time the system is armed
normally.
Two-Stage Door Unlock
If this feature is enabled on your system, pressing UNLOCK one time
will unlock only the driver’s door. Press UNLOCK again within 1
minute to unlock all doors.
Activating the Trunk Release Feature
Press and hold UNLOCK to open the vehicle trunk or hatch (if
equipped and connected). If this button is used to operate another
accessory, the accessory will stay active for as long as the button is
held.
Turning on the Vehicle Headlights/AUX 1
Press and hold the LOCK button to turn on the vehicle headlights.
(The alarm system will attempt to arm if not already armed, unless it
is in Valet Mode.) The lights will stay on for 20 seconds, or until LOCK
is pressed again.
AUX 2
If this feature is enabled on your system, pressing and holding AUX
for two seconds or Operating duration will activate AUX 2.
AUX 3
If this feature is enabled on your system, holding AUX and
immediately pressing LOCK for one second or Operating duration will
activate AUX 3. If the personalized transmitters feature is enabled
on your system, this output is used to activate the memory seat
feature for driver 1.
AUX 4
If this feature is enabled on your system, holding AUX and
immediately pressing UNLOCK for one second or Operating duration
will activate AUX 4. If the personalized transmitters feature is
enabled on your system, this output is used to activate the memory
seat feature for driver 2.
Using the Progressive Car Finder Feature
Press FIND/PANIC on the remote control to locate your vehicle. The
vehicle’s horn will emit five short chirps at low volume, increasing in
volume each of three times the button is pressed. If Songbird is
enabled and programmed to this function, the siren will emit the
programmed song.