Filter
Top Products
12
Deleting Lost or Stolen Remote Controls from Your System
If one of your remote controls is lost or stolen, follow these instructions
IMMEDIATELY to remove the control code from your system.
1. Have all remaining remote controls available.
2. Enter the control programming mode by following steps 1 - 5
of Adding Remote Controls to Your System.
3a. If you have only one remaining remote control, press the
LOCK button on that remote control four (4) times, pausing
at least 1 second in between each press. The horn must
“honk” each time you press the LOCK button.
3b. If you have two remaining remote controls, press the LOCK
button on each remote control two (2) times, pausing at least
1 second in between each press. The horn must “honk” each
time you press the LOCK button.
3c. If you have three remaining remote controls, press the
LOCK button on one remote control twice, then press the
LOCK button on the remaining remote control once. Pause at
least 1 second in between each press. The horn must “honk”
each time you press the LOCK button.
4. Turn the vehicle ignition off to exit the programming mode.
When you are finished, the lost or stolen remote control will
no longer operate your system.System Maintenance, cont’d
Basic Troubleshooting
This section outlines some of the basic issues you may experience
while becoming used to the Code Alarm CA-140
TM
. If you have a
problem that is not covered by this section, please consult your installer.
motpmyS melborP noituloS
seodlortnocetomeR
krowton
yrettabdaedrokaeW
tonlortnocetomeR
demmargorp
yrettabegnahC
etomermargorP
)8egap(lortnoc
mratonlliwmetsyS
rehtororooD
neposiecnartne
nosithgilysetruoC
telaVnisimetsyS
edom
ecnartneesolC
ffothgilysetruocnruT
edomtelaVffonruT
)6egap(