Filter
Top Products
Nothing Comes Close to a Cobra
®
39
“PRESET MODE”: Applies the Fish Finder operating mode presets.
“WHITE LINE”: Used to monitor how the Fish Finder device displays
information about the nature of a bottom (soft or hard). The thin White Line
indicates a softer bottom whereas a thick White Line indicates a harder
bottom. When this function is set for “OFF”, the bottom return displays as
red and contains no information on bottom hardness.
“SENSITIVITY”: Quick Access to some of the most commonly used
controls for Fish Finder performance.
“FREQUENCY”: Changes the frequency of a sonar signal between 50kHz
and 200 kHz, providing optimal bottom and fish detection in both shallow
and deep water. Each frequency can be displayed individually in full
screen mode, or simultaneously in dual frequency mode.
“DUAL FREQUENCY SCREEN”: Divides the screen to show the 50 Khz
images on one side and the 200 Khz images on the other side.
“GAIN MODE”: Controls the sensitivity of the unit’s receiver, which
provides some flexibility in the display. To see more details increase the
receiver sensitivity by selecting a higher gain percentage. To decrease the
rate of details, select a lower gain percentage.
“RANGE MODE”: Selects the range options.
“DEPTH MODE”: Selects the depth options.
“RESET DEPTH LIMITS”: Allows the user to eliminate the Depth Limits
and start viewing the full or specified depth range.
“SCROLLING SPEED”: Adjusts the chart scrolling rate. Note that the
scrolling rate is limited by the sound speed and the depth with the following
relation: the deeper the setting, the slower the scrolling rate. 100% is the
maximum possible.
“INTERFERENCE REJECTION”: Enables a filter to remove interference
from other Fish Finders.
“BACKGROUND COLOR”: Changes the color scheme of the Fish Finder
Fish Finder Page