Filter
Top Products
High-output MultiSound Medallion™ Siren
All the siren electronics are in the system control unit rather than the siren itself. This
protects them from heat, dirt and exposure to the elements (other alarm companies’
sirens are far more susceptible to failure). Your Concept 60 also provides these
additional features:
Personalized Siren Sounds: Most alarm sirens have a single “warble” tone. A few
offer “six-tone” sirens that cannot be adjusted or require destruction of circuit
wires to change the sounds (the change is permanent and cannot be changed
again). Your siren is different. As shipped from the factory, it sounds six different
alarm sounds. However, you may turn any of the six sounds on or off to create a
different combination of sound patterns. In all, there are 64 different
combinations. You may set your own Personalized Siren Sounds so if you hear a
siren at a distance, you will know for sure whether it is your car or someone
else’s. See
User-selectable features
on pages 21-25.
QuietChirps™: You can control the volume of the normal arm and disarm chirps.
As shipped from the factory, your system issues full-volume chirp
acknowledgments. If you prefer, you may reduce the chirp volume to a level that
is clearly audible, yet less obtrusive. See the
User-selectable features
section on
pages 21-25.
Long-term chirp silencing: Whenever you wish, you may silence your Concept
60’s arm and disarm chirps until you decide to restore them. The parking light
flashes will continue to provide visual confirmation of remote controlled arming
and disarming. See User-selectable features on pages 21-25.
Remote controlled chirp muting: Remote controlled chirp muting capabilities are
especially valuable when parking late at night in a quiet residential area or any
other time when you want to arm or disarm silently. To arm or disarm silently,
simply press button 3 (channel 3) on your remote control instead of the usual
button 1 (channel 1).
Siren duration: When the system detects an intrusion attempt, the alarm is set to
sound for 30 seconds. However, if you prefer, you may change it to 60 seconds.
See the
User-selectable features
section on pages 21-25.
20