Filter
Top Products
Smart AutoTesting™
Each time you remotely arm the system, it tests all triggers and sensors. If the hood or
trunk is open when you remotely arm, the system will immediately alert you of the
problem by sounding 4 chirps and 4 parking light flashes instead of the usual 2 and 2. If
a door is ajar, you will receive the usual 2 chirps and flashes, then, 5 seconds later, there
will be 4 chirps and 4 flashes. (This door ajar warning will not work on vehicles that
have factory-delayed courtesy lights). If a sensor is malfunctioning, you will receive the
usual 2 chirps and 2 flashes, then, 10 seconds later, there will be 4 chirps and 4 flashes.
NOTE: Since this is a warning indication, you will hear the 4 chirps even if you
have the chirp muting feature turned on.
Specific malfunction identification: The system can also indicate the specific trigger
or sensor that is malfunctioning. If you get the 4-chirp/4-flash signal upon arming,
perform the following to identify the malfunctioning trigger or sensor:
1. Remotely disarm, then turn on the ignition. The LED status indicator inside your
vehicle will be flashing, pause, then repeat.
2. Count the number of blinks in one cycle between pauses (for your convenience, the
blink cycle repeats a total of 5 times) and refer to the chart below:
Number of LED blinks between pauses Malfunction
1 blink
Piezo Sensor
2 blinks
Glass Tampering Sensor
3 blinks*
Door trigger*
4 blinks
Trunk trigger
5 blinks
Hood trigger
6 blinks
Optional sensor #3
* If your vehicle has a factory-installed feature that turns off or dims the interior courtesy lights
several seconds after you exit the vehicle, the system cannot provide this indication.
Automatic malfunction bypass
To provide the utmost protection even if a system component malfunctions, the system
will automatically bypass any faulty point and arm all other triggers and sensors to
provide the utmost possible protection until you can have the system serviced by your
local Authorized Clifford Dealer. If you accidentally armed with the hood, trunk or a
door open, just close the open point and the system will again monitor that point.
Smart prior intrusion attempt alert
If you hear three chirps when you remotely disarm, it means that a trigger or sensor was
activated in your absence. When you enter the vehicle and turn on the ignition (or start
the engine), the LED will blink 1–5 times, pause, then repeat the blink cycle 4 more
times. Count the number of blinks in one cycle and refer to the chart above.
18