Filter
Top Products
Programmable
Feature
Parameter Action
Step Number
1 2 3 4 5 6 7 8 9 10 11 12 13 14
Personalized
Siren Sound
Any pattern
of up to 8 dots
and/or dashes
Flick switch to
M M L C M M M L C
Number of chirps 2 3 3
3
Special instructions
2
Siren duration
From 1 second
to 5 minutes
Flick switch to
M M L C M M L C L
4
C
Number of chirps 2 2 1 3
Optional
OmniSensor
Sensor
Sensitivity
Flick switch to M L C M L C L C
Number of chirps 1 1 3
5
3
Special instructions
6 7
Add a new
remote control
Channel 1
(arm/disarm)
Flick switch to
M M M L C M L C
Number of chirps 3 1 3
Special instructions
8
Channel 2
(accessory)
Flick switch to
M M M L C M L C L
Number of chirps 3 1 3
Special instructions
9
Channel 3
(accessory)
Flick switch to
M M M L C M M L C
Number of chirps 3 2 3
Special instructions
10
Channel 4
(accessory)
Flick switch to
M M M L C M M L C L
Number of chirps
3 2 3
Special instructions
11
2 Enter your TAP/HOLD/LATCHED sequence.
3 If you code has exactly 8 dots/dashes, you will hear 3 chirps after the 8th TAP or
HOLD to confirm programming completion. If your code has less than 8 dots/dashes,
turn off the ignition key after the final TAP or HOLD.
4
Leave the switch in latched position for the desired siren duration, then flip to center.
5 Simultaneously, 10 seconds of low-level beeping will begin.
6 Turn off the ignition key.
7
a) Exit and wait for OmniSensor beeping to stop.
b) Gently “thump” the windshield and listen for a long-beep confirmation.
c) Wait 20 seconds for 6 beeps, confirming sensor programming completion.
d) Arm with the remote control,
wait 5 seconds,
then test.
8 Press remote control button I/channel 1.
9 Press remote control button II/channel 2.
10
Press remote control button III/channel 3.
11 Press remote control button IV/channel 4.
18