Filter
Top Products
How to Program Your AvantGuard II
NOTE: A Quick Programming Guide is on pages 17-19. However, if you are
programming the system for the first time, we strongly recommend that you
follow the detailed instructions in the specific sections that follow before
attempting to use the guide.
F
or your convenience, everything was preprogrammed for you at the
Clifford Electronics factory. If, however, you would like to set your
AvantGuard II to meet you own specific needs and preferences, doing
so is as simple as a few flicks of a switch.
NOTE: If you wish to program more than one feature at a time, you do not
need to exit and re-enter the program mode for each feature separately.
Simply leave the ignition on after programming the first feature and continue
with STEP 3 of the next feature you wish. When all programming is complete,
place the switch in its center position, then turn off the ignition.
How to Change Siren Duration
Siren duration is the period of time the siren will sound when
the system detects an intrusion attempt. Siren duration is
factory preprogrammed for 30 seconds. You may change the
siren duration to any time interval from 1 second to 5 minutes. To program siren
duration, use the following procedure:
1. Turn ignition to the ON position.
2. Within 10 seconds, press and hold the valet/program switch to its momentary
(spring-loaded) position until you hear 1 chirp, then release the switch. The LED
will light in red and stay lit, confirming that the system is now in program mode.
3. Tap the switch to its momentary position 2 times.
4. Flip the switch to its latched position, then back to center. You will hear 2
chirps.
5. Tap the switch to its momentary position 2 times.
6. Flip the switch to its latched position, then back to center. You will hear 2
chirps.
7. Flip the switch to its latched position. You will hear 1 chirp to confirm that the
siren duration timer has been started. Leave the switch in the latched position
for the desired duration.
8. When the desired duration is achieved, flip the switch to its center position.
9. You will hear 3 chirps to confirm that you’ve programmed siren duration. Either
proceed to step 3 of the next feature you wish to program, or turn the ignition off
to exit program mode (you will hear 3 chirps and the LED will turn off to confirm
that the system has exited program mode).
11