Filter
Top Products
39
© 2005 directed electronics, inc.
2244--hhoouurr ttiimmeerr mmooddee
To enter timer mode, press and simultaneously. The 2-
way remote will produce a melody and the clock indicator will
appear on the remote’s LCD. Once in Timer Mode, the system
will remote start every 24 hours. Repeat this procedure to turn
Timer Mode off.
ddiiaaggnnoossttiiccss
The microprocessor at the heart of your system is constantly
monitoring all of the switches and sensors connected to it. It is
designed to detect any faulty switches and sensors and prevents
them from disabling the entire system. The microprocessor will
also record and report any triggers that occurred during your
absence. Refer to the
System Status Chirps
and
Table of Zones
sections of this guide for diagnostic information.
note: Arming and disarming the system does not reset
this function! The only ways to reset a bypassed zone are
for it to not trigger for 60 minutes, or to turn on the igni-
tion. If testing your system, it is important to remember
that the NPC
™
programming can cause zones to be
bypassed and appear to stop working. If five chirps are
heard when disarming, NPC
™
has been engaged. If you
wish to clear the NPC
™
memory, turn the ignition on.