Filter
Top Products
19
© 2005 directed electronics, inc.
Command Page
When a command (arm/disarm, remote start, or auxiliary
channel) from the transceiver is sent and received, the system will
send a command page back to confirm receipt.
Page Recognition Mode
The transceiver will leave a zone icon illuminated when it has
received a triggered response and will wait for violation recogni-
tion. Press any button on the transceiver, the LCD information
and alarm page alerts will be cleared.
uussiinngg yyoouurr ssyysstteemm
warning! safety first
The following safety warnings must be observed at all times:
➤ Due to the complexity of this system, installation of this
product must only be performed by an authorized Ungo
dealer.
➤ When properly installed, this system can start the vehicle via
a command signal from the remote control. Therefore, never
operate the system in an enclosed area or partially enclosed
area without ventilation (such as a garage). When parking in
an enclosed or partially enclosed area or when having the
vehicle serviced, the remote start system must be disabled
➜
note: The transceiver buttons will not send a command
to the system until the alarm page is cleared.