Filter
Top Products
Black plate (4,1)
Chevrolet Silverado Owner Manual - 2011
3-4 Seats and Restraints
Folding the Bench Seat
To fold the bench seat:
1. Push back the front of the
seatback.
2. Pull one of the release levers,
located on the lower part of the
rear seatback on each end of
the seat, completely out.
3. Hold the lever out and fold the
seatback forward until it rests on
the seat.
4. Release the lever.
Do not try to release the
seatback before pulling the
release levers because it can
damage the release system.
{
WARNING
If either seatback is not locked, it
could move forward in a sudden
stop or crash. That could cause
injury to the person sitting there.
Always push and pull on the
seatbacks to be sure they are
locked.
{
WARNING
A safety belt that is improperly
routed, not properly attached,
or twisted will not provide the
protection needed in a crash.
The person wearing the belt could
be seriously injured. After raising
the rear seatback, always check
to be sure that the safety belts
are properly routed and attached,
and are not twisted.
Reverse the steps to raise the
seatback. Push and pull on the
seatback to make sure the seatback
is locked in the upright position
before driving. Make sure the safety
belts are not twisted or caught in the
seatback.