Filter
Top Products
Black plate (31,1)
Chevrolet Camaro Owner Manual - 2010
Infotainment System 6-31
Using the Digit Dial Command
1. Press
b g. The system
responds “Ready” followed by
a tone.
2. Say “Digit Dial”. The system
responds “Digit dial using
<phone name>, please say the
first digit to dial” followed by
a tone.
3. Say the digits to be dialed one
at a time. The system repeats
back the digit it heard followed
by a tone.
4. Continue entering digits until the
number to be dialed is complete.
After the whole number has
been entered, say “Dial”. The
system responds “OK, Dialing”
and dials the number.
.
If an unwanted number is
recognized by the system,
say “Clear” at any time to
clear the last number.
.
To hear all of the numbers
recognized by the system,
say “Verify” at any time.
Using the Call Command
1. Press
b g. The system
responds “Ready” followed
by a tone.
2. Say “Call”. The system responds
“Call using <phone name>.
Please say the name tag”
followed by a tone.
3. Say the name tag of the person
to call.
.
If the system recognizes
the name tag it responds
“OK, calling, <name tag>”
and dials the number.
.
If the system does not
recognize the name tag,
it confirms the name tag
followed by a tone. If the
name tag is correct, say
“Yes”. The system responds
“OK, calling, <name tag>”
and dials the number. If the
name tag is not correct, say
“No”. The system will ask
for the name tag again.
Once connected, the person called
will be heard through the audio
speakers.
Using the Re‐dial Command
1. Press
b g. The system
responds “Ready” followed by
a tone.
2. After the tone, say “Re‐dial”.
The system responds “Re‐dial
using <phone name>” and dials
the last number called from the
connected Bluetooth phone.
Once connected, the person called
will be heard through the audio
speakers.
Receiving a Call
When an incoming call is received,
the audio system mutes and a ring
tone is heard in the vehicle.
.
Press b g to answer the call.
.
Press c $ to ignore a call.