Filter
Top Products
To quickly adjust balance or fade to the middle position,
press the pushbutton positioned under the BAL or FADE
label for more than two seconds. A beep sounds and the
level adjusts to the middle position.
To quickly adjust all speaker and tone controls to the
middle position, press the
a knob for more than
two seconds until a beep sounds.
Digital Signal Processing (DSP)
This feature is used to provide a choice of four different
listening experiences. DSP can be used while listening
to the audio system or a CD. To change the DSP mode,
press the
a (tune) knob until the DSP control label
displays. Press the pushbutton located under the
DSP label until the control labels display. Continue by
pressing the desired button below the control labels
on the display.
For more information on the control label displays,
see the following:
• Norm (Normal): Select this screen button to
adjust the audio for normal mode. This provides
the best sound quality for all seating positions.
• Driv (Driver): Select this screen button to adjust
the audio for the driver to receive the best
possible sound quality.
• Rear: Select this screen button to adjust the audio
for the rear seat passengers to receive the best
possible sound quality.
• Surround (Centerpoint
®
): Select this screen button
to enable Bose Centerpoint
®
signal processing
circuitry. Centerpoint
®
produces a full vehicle
surround sound listening experience from a CD,
MP3/WMA, or XM stereo digital audio source and
delivers five independent audio channels from
conventional two channel stereo recordings.
(Not available for AM, FM, or auxiliary sources.)
Digital Signal Processing (DSP) is only available on
vehicles that have the Bose
®
Premium audio system.
Finding a Category (CAT) Station
CAT (Category): The CAT button is used to find
XM™ (if equipped) stations while the radio is in the
XM™ mode. To find XM™ (if equipped) channels
within a desired category, perform the following:
1. Press the BAND button until the XM™ (if equipped)
frequency displays. Press the CAT button to display
the category labels. Continue pressing the CAT
button until the desired category name displays.
Another way to select a category is to press
the
sREV or \FWD button until the desired
category is selected.
3-104