Filter
Top Products
4. Press the pushbutton under the desired Speed
Compensated Volume setting (OFF, Low, Med,
or High) to select the level of radio volume
compensation. The display times out after
approximately 10 seconds. Each higher setting
allows for more radio volume compensation at
faster vehicle speeds.
AudioPilot
®
: If your vehicle has the Bose
®
audio
system, it has AudioPilot
®
noise compensation
technology.
To use AudioPilot
®
, do the following steps:
1. Set the radio volume to the desired level.
2. Press the MENU button to display the radio
setup menu.
3. Press the pushbutton located under the
AUTO VOLUM label on the radio display.
4. Press the ON or OFF button to turn this feature
on or off.
When turned ON, AudioPilot
®
continuously adjusts the
audio system equalization, to compensate for
background noise, so that your music always sounds
the same at the set volume level.
The feature is most effective at lower radio volume
settings where background noise can affect how well
you hear the music being played through your vehicle’s
audio system. At high volume settings there might be little
or no adjustments by AudioPilot
®
. For more information
on AudioPilot
®
, visit www.bose.com/audiopilot.
Finding a Station
BAND: Press to switch between AM, FM, or XM™
(if equipped). The selection displays.
a (Tune): Turn to select radio stations.
©SEEK ¨: Press the arrows to go to the next or
to the previous station and stay there.
To scan stations, press and hold either arrow for
three seconds until a beep sounds. The radio goes
to a station, plays for a few seconds, then goes to the
next station. Press either arrow again to stop scanning.
The radio only seeks and scans stations with a
strong signal that are in the selected band.
4 (Information) (XM™ Satellite Radio Service,
MP3/WMA, and RDS Features): Press this button
to display additional text information related to the
current FM-RDS or XM™ (if equipped) station, or
MP3/WMA song. A choice of additional information such
as: Channel, Song, Artist, CAT (category) can display.
Continue pressing the information button to highlight
the desired label, or press the pushbutton positioned
under any one of the labels and the information
about that label displays.
When information is not available, No Info displays.
3-101