Filter
Top Products
Windshield Washer
{CAUTION:
In freezing weather, do not use your washer
until the windshield is warmed. Otherwise the
washer fluid can form ice on the windshield,
blocking your vision.
J (Washer Fluid): Press and release this paddle,
located at the top of the turn signal/multifunction lever,
to spray washer fluid on the windshield. The wipers
will clear the windshield and either stop or return to
your preset speed. For more washer cycles, press
and hold the paddle.
_ (Heated Washer Fluid): The heated windshield
washer fluid system, if your vehicle has this feature,
may be used to help clear ice, snow, tree sap, or bugs
from your windshield. Sliding the switch on the turn
signal/multifunction lever to this position and then
releasing it will activate the heated windshield washer
fluid system. This activation will initiate four heated
wash/wipe cycles. The first heated wash/wipe cycle may
take up to 40 seconds to occur, depending on outside
temperature. After the first wash/wipe cycle, it may
take up to 20 seconds for each of the remaining cycles.
The heated windshield washer fluid system may be
turned off at any time by sliding the switch on the turn
signal/multifunction lever to this position again.
When the heated windshield washer fluid system is
activated under certain outside temperature conditions,
steam may flow out of the washer nozzles for a short
period of time before washer fluid is sprayed. This is
a normal condition.
WASHER FLUID LOW ADD FLUID will be displayed
on the Driver Information Center (DIC) when the
washer fluid is low. See DIC Warnings and Messages
on page 3-73.
3-15