Filter
Top Products
3. Press the TUNE/SEL knob to turn AVC on or
off. An X will appear in the box when AVC is
selected on.
4. Press the CLR button to exit the display. To
return to the original display, repeatedly press
the CLR button or wait for the display to
time out.
SOURCE: Press this button to select a source,
either radio or CD. The CD must be loaded
to select the source and to play. CD will appear
on the display if a CD is loaded. If a CD is
not loaded the display will not change from the
radio source.
Finding a Station
BAND: Press this button to select FM1, FM2, AM,
or XM1 or XM2 (if equipped).
Q SEEK R: Press the up or the down arrow to
go to the next or to the previous station and
stay there. SEEK will appear on the display. The
sound will mute while seeking.
The radio will only seek stations with a strong
signal that are in the selected band.
Q SCAN R: Press the SCAN button to enter
scan mode. SCAN will appear on the display.
Press the up arrow to scan to the next station.
The radio will go to a station, play for five seconds,
then go on to the next station. Press this button
again to stop scanning.
To scan preset stations, press and hold SCAN for
more than two seconds until you hear a beep
and PSCAN appears on the display. The radio will
go to the first preset station stored on your firm
keys, play for five seconds, then go on to the next
preset station. Press SCAN again to stop
scanning presets.
The radio will only scan stations with a strong
signal that are in the selected band.
263