Filter
Top Products
• Your vehicle’s windshield is covered with ice, dirt,
haze or other obstructions.
• Your vehicle is loaded such that the front end of the
vehicle points upward, causing the Intellibeam™
sensor to aim high and not detect headlamps
and taillamps.
• You are driving on winding or hilly roads.
You may need to manually disable or cancel the
high-beam headlamps by turning the low-beam
headlamps on, if any of the above conditions exist.
Disabling and Resetting Intellibeam™
at the Rearview Mirror
Intellibeam™ can be disabled and reset to the original
factory setting by using the controls on the inside
rearview mirror.
AUTO
3 (Intellibeam™ On/Off): To disable the
system, press this button on the inside rearview mirror.
The Intellibeam™ indicator will turn off and the will
not come back on until the Intellibeam™ button
is pressed again.
When Intellibeam™ has turned on the high-beams, pull
or push the high-beam stalk. This will disable
Intellibeam™. The Intellibeam™ indicator on the mirror
will turn off. To re-enable Intellibeam™, press the
Intellibeam™ button on the mirror.
A different sensitivity setting is available for dealer
diagnostics. This is done by pushing and holding this
button for 20 seconds until the light flashes three times.
If you accidentally activate this, the vehicle’s setting
will automatically be reset each time the ignition
is turned off and then on again; otherwise, refer to the
text above for resetting the system.
Cleaning the Intellibeam™ Light Sensor
The light sensor is located
on the inside of the vehicle
in front of the inside
rearview mirror.
Clean the light sensor window, periodically, using glass
cleaner on a soft cloth. Gently wipe the sensor
window. Do not spray glass cleaner directly on the
surface of the sensor window.
3-34