Filter
Top Products
Headlamps
The exterior lamp control is located in the middle of the
turn signal/multifunction lever.
O(Exterior Lamp Control): Turn the control with this
symbol on it to operate the exterior lamps.
The exterior lamp control has four positions:
O (On/Off): Turn the control to this position to turn off
all lamps and automatic lighting features including
Daytime Running Lamps and Intellibeam™.
This is a “momentary” switch that will spring back to the
AUTO position when released. An AUTOMATIC
LIGHTS ON message will appear on the DIC when
automatic lights are enabled or an AUTOMATIC LIGHTS
OFF message will appear on the DIC when the
automatic lights are disabled.
AUTO (Automatic): Turn the control to this position to
put the headlamps in automatic mode. AUTO mode,
if enabled, will turn the exterior lamps on and off
depending upon how much light is available outside of
the vehicle.
Due to the “momentary” switch design, your automatic
lights may be disabled even if you are in AUTO position.
To enable automatic lighting do any of the following:
• Turn the headlamp control from AUTO to off
and release the switch. It will return back to
the AUTO position by itself.
• Turn the headlamp control from the parking lamp
position to AUTO.
• Turn the headlamp control from the headlamp
position to AUTO.
To disable automatic lighting do any of the following:
• Turn the headlamp control from AUTO to off
and release the switch. It will return back to
the AUTO position by itself.
• Turn the headlamp control from AUTO to the
parking lamp position.
• Turn the headlamp control from AUTO to the
headlamp position.
Disabling automatic lighting will disable the automatic
headlamp operation, DRL, and Intellibeam™
High-Beams (if equipped).
3-31