Filter
Top Products
Black plate (87,1)
Buick Lucerne Owner Manual - 2011
Using the “Digit Dial” Command
The digit dial command allows a phone number to be
dialed by entering the digits one at a time. After each
digit is entered, the system repeats back the digit it
heard followed by a tone.
If an unwanted number is recognized by the system,
say “Clear” at any time to clear the last number.
To hear all of the numbers recognized by the system,
say “Verify” at any time.
1. Press and hold
b g for two seconds.
2. Say “Digit Dial”.
3. Say each digit, one at a time, that you want to dial.
After each digit is entered, the system repeats
back the digit it heard followed by a tone. After the
last digit has been entered, say “Dial”.
Once connected, the person called will be heard
through the audio speakers.
Using the “Re‐dial” Command
1. Press and hold b g for two seconds.
2. After the tone, say “Re‐dial”.
Once connected, the person called will be heard
through the audio speakers.
Receiving a Call
When an incoming call is received, the audio system
mutes and a ring tone is heard in the vehicle.
.
Press b g to answer the call.
.
Press c x to ignore a call.
Call Waiting
Call waiting must be supported on the cell phone and
enabled by the wireless service carrier.
.
Press b g to answer an incoming call when
another call is active. The original call is placed
on hold.
.
Press b g again to return to the original call.
.
To ignore the incoming call, no action is required.
.
Press c x to disconnect the current call and
switch to the call on hold.
Three‐Way Calling
Three‐way calling must be supported on the cell phone
and enabled by the wireless service carrier.
1. While on a call, press
b g.
2. Say “Three‐way call”.
4-87