Filter
Top Products
P.18 Installation Guide AS-6205 SH
Disarmed Notification
This feature will notify the user when the vehicle is left disarmed after Ignition is turned off, or
when the Module is disarmed after being previously armed, the opening or closing of a Door
will cause the Horn or the Siren to sound once after 10 sec. to warn the user that the vehicle
was left unprotected. Pressing
LOCK or UNLOCK will cancel this timer.
Two-Stage Disarm
When the Siren is sounding, pressing UNLOCK will stop the siren – but without unlocking or
disarming the vehicle. You can disable this feature by selecting corresponding option in the
Passive or Active Function.
Shock Sense Bypass
When AUX 3 is programmed for Trunk with Disarm/Rearm option, and the Trunk pin from the
vehicle has been connected to the Door Pin input wire (diode isolated), it is not necessary to
press on
UNLOCK to disarm the Alarm prior to pressing the TRUNK button.
When the Trunk is opened by remote control, the Door Zone/“Trunk pin” will be ignored; the
Shock Sensor will also be ignored until the Door Zone/”Trunk pin” closes. Monitoring will
resume 5 seconds after the Door Zone (Trunk pin) is closed.
Resetting The Module
The system is equipped with a reset function that allows the installer to erase all Transmitter
codes and return all programmed Options to the factory default values.
To reset the Module:
1. FLASH the Hood pin switch.
2. Before the 20 seconds have passed, Press the Valet Button 6 times or more, until
the Parking Lights start to flash.
3. The Parking Lights will flash 8 times confirming the Reset.
Table 12
Events Logging
The Module will play back the last 4 Start Failure Events Codes and the last Intrusion Code
via the Parking Lights and L.E.D.
Events playback
Ensure that the Hood is up and that the Ignition is OFF.
x Hold down the Hood Pin-switch for 4 seconds.
x Release the Pin-switch.
x The Parking Lights will come on.
x With the Parking Lights on, immediately push the Pin-switch 3 times.
x The Parking Lights and L.E.D. will flash the five events stored in memory.
The first four playback codes are Start Failure Events, while the last playback code is an
Intrusion Code. There is a pause after each event code is played back.
The system will play back the most recent event first, then the second most-recent, and so
on. If there are no events at all to report, the Parking Lights will give one long flash.
Start Failure Codes via Parking
Lights
1 x = No Start
3 x = Hardware Reset
4 x = Brakes
5 x = No Tach cut-off
6 x = Hood
7 x = Engine Running, no Ignition
detected, or Tach before Start