Filter
Top Products
The Programming
Assistance Button
(A.k.a. PAB.)
The PAB is located on the
side of the Module. This
push button mimics the
Hood-Pin switch in order to
avoid having to get out of
the vehicle and pressing the
Hood-Pin switch. The PAB
will work only when the
Hood is up.
How to Program the Transmitter.
1. FLASH the Hood Pin Switch.
Before the 20 seconds have passed, turn the Ignition Key to the IGNITION ON (RUN) position.
Turn the IGNITION to OFF.
2. Press and hold the LOCK button until the vehicle gives 5 flashes. The Module has
stored the Transmitter in its memory.
3. Close the Hood, to exit.
Table 1
The Module has the ability to retain up to 4 different Transmitter codes; if a fifth Transmitter is
programmed, the code of the first Transmitter will be erased from memory. To erase all
Transmitter codes from memory, you must perform a Module reset (See “Resetting the
Module” on page 18 ).
To program the Transmitter on a second vehicle (Multi-car Operation),
you must press the TRUNK button (of the secondary Transmitter you wish to
program) during step 2 of Transmitter Programming.
How to Enter Options Programming Mode
The System is equipped with three custom Programming Modes, allowing the installer to
custom-fit the system according to the requirements of each vehicle. When getting into the
Programming Option Mode, the Parking Lights and the Siren will flash and chirp once, twice
or three times depending on the option you have entered. The unit will stay in Programming
Mode until the Hood Pin-switch or the Brake Pedal is pressed again. Therefore take your time
to make the proper selection. To return to the Programming Centre (Main Menu), press on
the Brake Pedal.
1. FLASH the Hood Pin Switch.
Before the 20 seconds have passed,
2. Press and hold the Brake Pedal, then press one of the following buttons on the
Transmitter:
x LOCK to enter Mode 1;
x UNLOCK to enter Mode 2; or
x TRUNK to enter Mode 3.
The Parking Lights and the Siren will flash and chirp once, twice or 3 times to confirm
entry into a Mode.
3. Release the Brake Pedal.
Table 2
P.10 Installation Guide AS-6205 SH