Filter
Top Products
AS-6205 SH Installation Guide P.13
OPTION 2* Ignition Valet - ENABLED
OPTION 3 Ignition Valet - ENABLED
Horn Honk / Siren Timing (Optional)
1. Make sure that Mode 3 Function 4 Option1 or Option 3 is activated.
2. FLASH the Hood Pin Switch
Before the 20 seconds have passed,
3. Press and hold the Brake Pedal.
x Press the START and UNLOCK buttons simultaneously on the Transmitter.
x The Horn/Siren will sound 5 times.
4. Release the Brake Pedal.
5. To change the timing:
a. To increase the Horn Honk/Siren by 3 ms, press the LOCK button.
b. To increase the Pulse by 10 ms, press the START
c. To decrease the Pulse by 3 ms, press the UNLOCK button.
d. To decrease the Pulse by 10 ms, press the TRUNK button.
6. To save the setting: press LOCK and UNLOCK. If 3 Honks/Chirps are heard the new value
has been saved.
For each timing change, the Horn/Siren will sound with the new setting, except
under the following circumstances:
x When the lower limit of 5 ms is reached, the Horn/Siren will sound for 1/4 second.
x When the upper limit of 200 ms is reached, the Horn/Siren will sound for
3/4 second.
A system reset will set the system back to the default: 30 ms
Close the Hood to cancel the changes.
Table 4
Auto Tach Programming Procedure
NOTE:
If no tach has been programmed and the START button
is pressed, there will be no start attempt and the
vehicle will give 5 flashes.
If another Tach Programming is required, simply
repeat the Auto Tach Programming Procedures.
The Module stores the Tach setting, being Auto Tach
or conventional Tach, until the Module is reset.
This process can be carried out instead of the conventional Tach Programming Procedure.
1. Make sure all the connections are done properly and that the Module has been
powered-up.
2. With the Hood up (Ground on the Hood Pin line), start the vehicle using the key.
3. Let the Engine reach proper idle speed
The Parking Light output from the Module is activated when the vehicle starts and it
will shut off once the Tach signal is detected.
4. Press and hold the Brake Pedal until the Parking Light output from the Module
flashes 5 times.
5. Turn the Ignition OFF. At this point, the Tach setting has been programmed.