Filter
Top Products
REMOTE START FEATURES
The remote start feature is activated using the remote control transmitters.
START:
a) Press the red * (star) button for 2 seconds.
b) The vehicles parking lights will flash 2 times and stay “ON”.
c) All doors will lock.
d) The ignition will turn ON and check the system; after 3
seconds the vehicle will start.
e) Three seconds after start the Accessory will turn “ON”.
f) The vehicle will run for the length of run-time selected.
Operating during remote start function:
The remote start can function while the vehicle is in the Locked secured
mode. When the engine is running from the remote start you can insert the
key into the vehicle’s ignition and turn the key to the run position. Tap the
brake pedal, the remote start will shut down. The engine will remain
running from the key in the ignition.
REMOTE START SAFTEY FEATURES
If the remote start system detects any of the following
conditions prior to remote starting or while the vehicle is
running, the system will not start or will shut down the system
immediately if running.
SAFTEY FEATURES:
a) The vehicles hood is opened. !
b) The vehicles brake pedal is pressed.
c) The vehicles engine exceeds 2000 RPM idle speed. "
e) The programmable run time has elasped.
! Additional installation maybe required.
" When programmed to Tach Sensing only.
DIAGNOSTIC PARKING LIGHTS CODES
The system has a built-in diagnostic routine which indicates why the unit
turned the engine off. The parking will flash 1 to 5 times to indicate which
of the following caused the engine to shut off or not start from transmitter.
CODES:
1. 1 Flash ---- RPM fail
2. 2 Flash ---- Voltage fail
3. 3 Flash ---- Hood pin fail
4. 4 Flash ---- Brake Light fail