Filter
Top Products
Transmitter Programming
Enter:
1. Turn ignition switch ‘ON’.
2. Press the valet switch 3 times.
3. Horn will give one long chirp and the LED
will begin to flash once every 3 seconds.
Programming:
1. Press the any button on the first transmitter.
2. The horn will chirp 1 time.
3. Within 10 seconds push any button on the second
transmitter
4. The horn will chirp 2 times.
5. To program 3rd & 4th transmitters repeat steps
1 & 2 of programming.
Exit:
1. Turn the vehicle’s ignition to the ‘OFF’ position, Or Leave
for 10 seconds.
2. The horn will give 3 long chirps to confirm exiting program-
ming.
Second Vehicle Transmitter Programming
Your Autopage Remote Start System’s remote transmitter can
be programmed to control a second vehicle equipped with an
RST2050KE or RST2053AL. To program the transmitter to a
second vehicle, follow the instruction for transmitter program-
ming. All steps will be the same except for the following:
1. Prior to pushing any button on the transmitter.
Press the side Green shift button first.
2. Once the Green button is pressed the LED on the
transmitter will illuminate for 3.5 seconds
3. While the LED is illuminated, press any button on the
transmitter.
NOTE: The RST2050KE will only retain the last 4 remote transmitters
programmed into the system. If the transmitter memory is exceeded, the
RST2050KE will start deleting transmitters in the order of their
programming.