Filter
Top Products
Green w/ White trace Wire: Entry Illumination Ground Output
This wire provides a 30 second ground output (300 mA Max.) whenever the remote is used to disarm the
alarm or to unlock the doors and provides a continuous pulsed output whenever the alarm is triggered. This
wire should be connected to an external relay, and wired to the vehicles interior entry lighting whenever the
optional Interior Illumination circuit is desired. See below for relay wiring details.
Entry Illumination Detail
Grey w/ Black Trace Wire: Negative Inhibit Input
The Grey w/ Black Trace wire provides an instant shutdown for the Remote Start Control circuit whenever
it is grounded. Connect the Grey w/ Black trace wire to the hood pin switch previously installed. This wire
must be routed through a grommet in the firewall and connected to the hood pin switch. If the pin switch
is to be used with an alarm system, connect this wire using the diode assembly provided.
IMPORTANT!
This connection is a safety wire and must be connected as shown and tested as specified. Failure to do so
may result in personal injury or property damage. See detail of wiring in the following diagram. This wire may
also be used if the vehicle brake light circuit switches ground to the brake lights. An isolation diode must
be used for ground switched brake light circuits and must be connected to the output of the brake switch.
Grey w/ Black Trace Negative Inhibit Safety Shut Down Detail
9
128-5371
9of22