Filter
Top Products
chosen location to insure that the drill will not penetrate any existing factory wiring or fluid lines. Carefully
drill a 1/4" hole in the desired location and pass the connector end of the LED through the hole and toward
the control module. Press the LED firmly into place until it is fully seated in the mounting hole.
THE RECEIVER/ANTENNAASSEMBLY:
The Superheterodyne Receiver Antenna Assembly provided with this unit allows routing from below the
dash board for maximum operating range. Choose a location above the belt line (dashboard) of the vehicle
for best reception. Special considerations must be made for windshield glass as some newer vehicles
utilize a metallic shielded window glass that will inhibit or restrict RF reception. In these vehicles, route
the antenna toward a rear window location for best reception. Secure the antenna with double stick tape
provided. After securing the antenna, it is recommended to secure a section of the antenna cable to a
fixed support. This will prevent the antenna from dropping down in case the double stick tape is exposed
to extreme heat which may loosen it's gummed surface. Route the 3 pin connector toward the control
module using caution not to pinch the cable as this will cause poor or no RF reception to the control
module.
VALET/PROGRAM/MANUAL OVERRIDE SWITCH :
Select a mounting location that is easily accessible to the operator of the vehicle. It is not necessary to
conceal the switch. However, concealment is recommended as it offers a higher level of security. The
switch can be mounted to the lower dash panel in the driver's area. Inspect behind the chosen location to
insure that adequate clearance is allowed for the body of the switch, and also that the drill will not
penetrate any existing factory wiring or fluid lines. Drill a 1/4" hole in the desired location and mount the
switch by passing it through the panel from the underside. Secure the switch using the nut, star washer,
and on/off face plate. It is suggested that the switch be oriented to allow the on position to be up toward
the driver and the off position to be down or away from the driver. Route the switch's connector toward the
control module.
REMOTE START CONTROL SWITCH:
Select a mounting location known and accessible to the operator of the vehicle. A lower dash panel, kick
panel, or glove box is desirable. Inspect behind the chosen location to insure that adequate clearance is
allowed for the body of the switch, and also that the drill will not penetrate any existing factory wiring or
fluid lines. Drill a 1/4" hole in the desired location and mount the switch by passing it through the panel
from the underside. Secure the switch using the nut, star washer, and on/off face plate. It is suggested
that the switch be oriented to allow the on position to be up toward the driver and the off position to be
down or away from the driver. Route the switch's connector toward the control module. Place the RED
rubber boot, included in the kit, over the switch handle to differentiate this switch from the valet/program
switch.
SHOCK SENSOR:
Select a centrally located, solid mounting surface for the shock sensor that will allow consistent operation
from all areas of the vehicle. The selected location must be within 18" of the control module to allow
routing and connecting of the 4 pin harness. Secure the shock sensor to the chosen location using two
#8 self taping sheet metal screws. The sensor can also be secured to an existing dash brace using cable
tie straps. Whichever mounting method is used be sure to allow access to the sensitivity adjustment
potentiometer for use later in the installation.
STARTER INHIBIT RELAY:
Select a mounting location within 12" of the ignition switch's low current start solenoid wire. Secure the
relay to an existing harness in the chosen location using a cable tie around the relay's wiring harness.
Caution! Do not wire tie the metal bracket to an existing wiring harness as vibration may cause chaffing
and shorting, damaging the factory wiring. If an existing harness is not available then secure the relay's
metal mounting tab to an under dash metal brace with a #8 self taping sheet metal screw. Wire the relay
as per the diagram found later in this manual.
128-5371
3of22
3