Filter
Top Products
8
FEATURE ACTION TO PERFORM RESPONSE FROM SYSTEM LED FLASH PATTERN
To Turn the Ignition Switch ON LED Turns OFF
Enter Toggle the Valet/Program/Manual Override Switch
The ON then OFF 3 Times 1 Siren/Horn Chirp & 1 LED Flash
Pro
g
rammi
n
Within 3 seconds,
Mode turn the Ignition Switch OFF, then ON 1 Short Chirp, and 1 Long Chirp
First Press Transmitter Lock/unlock Button to Adjust Feature 1 Chirp = Passive Arming ON 1 Flash, Pause, Repeat
2 Chirps = Active Arming ON
Second Press Transmitter Lock/unlock Button to Adjust Feature 1 Chirp = Ign Locking ON 2 Flashes, Pause, Repeat
2 Chirps = Ign Locking OFF
Third Press Transmitter Lock/unlock Button to Adjust Feature 1 Chirp = Ign Unlocking ON 3 Flashes, Pause, Repeat
2 Chirps = Ign Unlocking OFF
Fourth Press Transmitter Lock/unlock Button to Adjust Feature 1 Chirp = Passive Doorlock ON 4 Flashes, Pause, Repeat
2 Chirps = Passive Doorlock OFF
Fifth Press Transmitter Lock/unlock Button to Adjust Feature 1 Chirp = Chirps ON 5 Flashes, Pause, Repeat
2 Chirps = Chirps OFF
You have now engaged the Programming Mode, and are set to adjust the First feature
This mode will time out automatically in 15 seconds, or can be cancelled by turning the Ignition Switch OFF
OR
Toggle the Valet/Program/Manual Override Switch once to Advance to the next feature
OR
Toggle the Valet/Program/Manual Override Switch once to Advance to the next feature
OR
Turn the Ignition Switch OFF to exit the Programming Mode
NOTE:
If you accidentally toggled past the feature you intended to adjust, you must exit and re-enter the mode.
OR
Toggle the Valet/Program/Manual Override Switch once to Advance to the next feature
OR
Toggle the Valet/Program/Manual Override Switch once to Advance to the next feature
EX-6000.
COMPLETING THE INSTALLATION:
After you have confirmed the operation of the EX-6000, and tested any and all optional features of the
system:
1. Mount the control module up and behind the dash securing it in place with cable ties or screws. Be
certain that the chosen mounting location will not inhibit any of the controls of the vehicle.
2. Securely harness and tie all wiring up and away from all hot and moving parts that they may come in
contact with under the dash board or in the engine compartment areas.
CAUTION:Particularly avoid the area around the steering shaft and column, as wires can wrap around
these mechanisms and impair the safe operation of the vehicle.
3. Check the vehicle's wipers, lights, horn, etc... to insure proper operation.
4. Replace all panels that were removed during installation, and retest the system.
5. Explain the operation of the system and its various features to the end user if available, and place the
Owner's Manual on the dashboard for them to find and review.