Filter
Top Products
7
Programmable Features:
Features 1 Chirp 2 Chirp Default
First Passive Arming Active Arming Passive Arming
Second Ignition D/L ON Ignition D/L OFF Ignition D/L OFF
Third Ignition D/UL ON Ignition D/UL OFF Ignition D/UL OFF
Fourth Passive D/L Active D/L Active D/L
Fifth Chirps ON Chirps OFF Chirps ON
To Program These Features:
Entering the Programming Mode involves operating the Ignition Switch and the Valet/Program/Manual Over-
ride Switch in a particular sequence. This sequence is very time dependent, in other words it must be
performed quickly in order for you to enter the mode. This sequence is also only one step different from
the Transmitter Programming Mode, so make certain you perform the sequence properly.
Upon entering the Programming Mode, the system is immediately set to allow adjustment of the First
Programmable Feature. That First feature, "Passive or Active Arming", can then be set ON or OFF by
pressing the lock/unlock button of the transmitter. The system confirms that it is set to adjust the First
feature by repeatedly flashing the LED once, with a pause in between each flash. The system will then
report how the feature has been set by the number of chirps heard after pressing the transmitter button.
Toggling the Valet/Program/Manual Override Switch once again will advance you to the Second Pro-
grammable Feature, confirmed by a repeating two LED flashes, with a pause in between each flash, etc.,
etc.
It is important to note that when you first enter the Programming Mode, you are automatically positioned to
adjust the First Programmable Feature, and that the Valet/Program/Manual Override Switch allows you to
toggle from there through each of the four more programmable features. However, it will not allow you to
return to any feature once you have toggled past it. Should you accidentally toggle past the feature you
wanted to program, you must exit and re-enter the Programming Mode and then adjust the feature you
missed.
It is also important to note that you may toggle past as many programmable features as you wish without
having to adjust them. Each time you toggle forward to a new feature, the siren will chirp the appropriate
number of times (1 or 2 times) to indicate how that feature is currently set, and the LED will flash the
appropriate number of times to indicate the number of the feature (First through Fifth) that you are set to
adjust. For example, you might enter the mode and toggle the Valet/Program/Manual Override Switch 3
times in order to adjust the Fourth programmable feature. The system would respond with 1 Chirp, and
the LED would begin to flash 4 Flashes, pause, and repeat. This has told you that the system is ready for
you to adjust the Fourth programmable feature, and that it is currently programmed for Chirps ON. A
single press of the lock/unlock button of the transmitter will cause the system to produce 2 Chirps. This
signifies that you have changed the programming to Chirps OFF. Please follow the programming
procedure carefully, and refer to the list of the Programmable Features above when programming the