Filter
Top Products
INSTALLATION - REAR WHEEL DRIVE VEHICLES
EXISTING CABLE OR
BRACKET ON VEHICLE
CABLE TIE
PULL
TIGHT
DRILL 3/16" DIA HOLES IN
FLOOR PAN OF VEHICLE
DRIVE SHAFT
12" MAX. DISTANCE
FROM U-JOINT
1/2"
POSITION SPEED SENSOR HORIZONTALLY
TO ALLOW FOR UP AND DOWN MOTION OF
DRIVESHAFT
VEHICLE FLOOR
CLEARANCE 3/8"
FABRICATED BRACE TO
STIFFEN PICK-UP COIL
BRACKET
DRIVE SHAFT
Figure 1
CUT STRIP ALONG THIS LINE
Figure 2
Figure 3
PICK-UP COIL AND BRACKET ASSEMBLY
Figure 5
Figure 4
-14-