Filter
Top Products
1. Choose a flat location on the dashboard that is visible while driving. The location should be very accessible
to the driver, allowing easy activation of the switch while operating the cruise control. A template has been
provided to confirm that there is adequate space for mounting the switch in the selected location. (Fig.1)
2. After the location is selected, check the area behind the panel to be sure that the wires can be routed to the
cruise control harness connector. You should also make sure that the drill will not damage any components
or wiring behind the panel, and it is always best to remove the panel before drilling.
3. Drill (2) 1/4" diameter holes in the location marked on the template. After drilling, use a file or razor knife
to remove the dash material between the (2) holes.
4. Clean the area of the dashboard where the switch will be mounted, and allow any cleaning fluids to dry
completely.
5. Pass the wires from the switch through the hole in the panel, remove the paper lining from the mounting pad
on the back of the switch, properly align the switch, and firmly press in place on the panel. (Fig.2)
6. Route the 6 wires from the switch to the control switch connector from the cruise control main wiring harness.
Be sure to avoid any sharp or moving surfaces when routing wires, and secure the wires along their path
using tie straps.
7. Plug the terminated ends of the Red, Brown, Green and Yellow wires into the color coded locations on the
connector. Be sure that the terminals click, and are fully seated in the connector. (Fig.3)
8. Plug the switch connector into the mating connector on the main cruise control harness.
9. Connect the Black wire from the switch to a known chassis ground source.
10. Connect the Grey wire from the switch to the parking light wire in the vehicle. When probed, the parking
light wire will read +12 VDC when the parking lights are on, and 0 VDC when the parking lights are off.
The Grey wire controls the backlighting of the switch, and the switch will not illuminate if the Grey wire is left
disconnected. You must connect all other wires from the switch, or the cruise control will not operate.
DASH MOUNTED (norDASH MOUNTED (nor
DASH MOUNTED (norDASH MOUNTED (nor
DASH MOUNTED (nor
mally open)mally open)
mally open)mally open)
mally open)
CRUISE COCRUISE CO
CRUISE COCRUISE CO
CRUISE CO
NTRNTR
NTRNTR
NTR
OL SWITCHOL SWITCH
OL SWITCHOL SWITCH
OL SWITCH
INSTINST
INSTINST
INST
ALLAALLA
ALLAALLA
ALLA
TITI
TITI
TI
OO
OO
O
NN
NN
N
-8-
5. Locate the fused wire with switch connector included in the kit, and load the Brown, Green, and Yellow wires
from the main harness into the 4 pin switch connector. Be sure to load the wires according to the color coded
label on the connector, and press the terminals in fully until a click is heard.
6. Orange Wire : Connect the Orange wire from the fuseholder to a wire in the vehicle that shows + 12 VDC when
the ignition key is switched On and 0 VDC while cranking and when the key is switched OFF. Use a blue scotch
lock connector to make this connection.