AstroStart 2305A Remote Starter User Manual


 
7
By default, the commands executed by the remote are those of Group 1. To perform a command from Group 2, you
must first press the button (2 sec.), and then press the button(s) corresponding to the desired command. The
remote control remains in Group 2 for 10 secondes (to execute the command). If the button is pressed (2 sec.)
when the remote is in Group 2, it switches to Group 1.
A : The system is ready for a start. B : Start will not be possible. C : Start was successful. D : Start was not
successful. In such a case, the remote beeps the number of time corresponding to the start fail code.
Horn sounds on each subsequent command (programming required at installation).
This command ends runtime, "Panic" mode and alarm status.
Temporary "Valet" mode if pressed a second time during rearming delay.
System can be programmed so that "Trunk" command is replaced by "Utility 1" command.
If the system is not ready to execute the command (ex.: engine kept running by ignition key).
Horn plays a short melody.
Buttons blink 1 to 4 times when remote is in silent mode.
Combination depending upon status of engine and status of locks.
Confirmations emitted by vehicle
The confirmations emitted by the vehicle are generated as soon as the start module receives the command. In most cases,
your remote starter will confirm that the command has been received, by either sounding the horn or the siren, or by flashing
the parking lights.
The confirmations emitted by the parking lights are mandatory while those emitted by the horn or the siren are optional
(programmable) and can require additional connections and components at time of installation. Many of these confirmations
depend on the status of the system when the command is emitted. Refer to paragraphs relating to each command for more
details on confirmations.
OTHER CONFIRMATIONS
The system emits other types of confirmations. Unlike the confirmations shown in the command table and executed
immediately after the emission of a command, the following confirmations can occur at any time.
REMOTE CONTROL VEHICLE
CONFIRMATIONS
B
UTTON
(LED)
PIEZO
(B
EEP)
M
ECHANICAL
(VIBRATION)
L
IGHTS SIREN
RUNTIME OVER
ENGINE STALLED
ENGINE STOP
STOP BY ALARM
2
X
1 - -
ALARM *
A
1 (3 )
END OF ALARM *
- - -
PRE-SHOCK *
B
1 (3 )
S
EE SECURITY
S
YSTEM ON PAGE 11.
OPEN > 5 MIN. 1X 1 2 - -
TRUNK OR DOORS *
CLOSED 2X 2 - - -
LEFT ON 1X 1 2 LEFT ON -
LIGHTS
TURNED OFF 2X 2 - TURNED OFF -
AND DOORS LOCKED 1X 1 - 1 1
SYSTEM ARMED *
AND DOORS UNLOCKED 2X 2 - 1 1
END OF DELAY - OUTPUT 1 OR 3 2X 2 - 1 -
UTILITY OUTPUT
END OF DELAY - OUTPUT 2 OR 4 2X 2 - 1 -
ACTIVATE 1X 1 - 4 -
VALET MODE
CANCEL 2X 2 - 2 -
REMOTE CODE MEMORIZED
1 - -
PAGER
30 SEC. - (30 SEC. ) 1 -
* CONFIRMATIONS FOLLOWED BY AN ASTERISK (*) APPLY ONLY TO COMMAND UNITS EQUIPPED WITH A SECURITY SYSTEM.
SYSTEM CAN BE CONFIGURED TO INDICATE AN ALARM STATUS FROM VEHICLES ORIGINAL SYSTEM.
A : SEQUENTIAL, REPEATING AS LONG AS ALARM CONDITION PERSISTS. B : SEQUENTIAL, REPEATED FROM 3 TO 6 TIMES.
WHEN IN MUTE MODE.